Drag and Drop Questions
Here you will find answers to Drag and Drop Questions
Question 1
Drag and drop the proper command in the proper order to create a
MP-BGP session between two PE routers that will be used to support the
RED VPN
Answer:
Command 1: router bgp 65001
Command 2: neighbor 172.16.1.2 remote-as 65001
Command 3: neighbor 172.16.1.2 update-source loopback 0
Command 4: address-family vpnv4
Command 5: neighbor 172.16.1.2 activate
Question 2
Drag and drop the proper command in the proper order to configure
EBGP as the CE to PE routing protocol for VPN RED on a PE router.
Answer:
Command 1: router bgp 65001
Command 2: address-family ipv4 vrf RED
Command 3: neighbor 172.16.1.2 remote-as 65002
Question 3
Drag and drop the proper command in the proper order to redistribute the RED VPN routes from the EIGRP vrf into the BGP vrf
Answer:
Command 1: router bgp 65001
Command 2: address-family ipv4 vrf RED
Command 3: redistribute eigrp 101
Question 4
Drag the BGP MED function on the left to the command that enables it on the right. Not all apply
Answer:
bgp deterministic med: Enforce the comparison of MED between all paths received from the same autonomous system
bgp always-compare-med: Allow the comparison of MED for paths from neighbors in different autonomous systems
bgp bestpath med-confed: Enable MED comparison among paths learned from confederation peers
Question 5
CE1A and CE2A belong to the Customer_A VPN. Select the correct
command for the PE1 router to establish static routing from PE1 to the
CE1A 192.168.1.0/24 network by selecting them from the dropdown menus
below. Some of the commands must be entered in the correct order. Also
enable propagation of the static route into MP-iBGP. Assume the MP-iBGP
session between PE1 and PE2 have been configured already.
Answer:
1. ip route vrf Customer_A 192.168.1.0 255.255.255.0 10.1.1.2 Serial0/0
2. router BGP 50111
3. address-family ipv4 vrf Customer_A
4. redistribute static